Radar

Area of Responsibility

Wunstorf Radar is responsible for departing and arriving traffic from/to ETNW. 

When online, Wunstorf Radar activates its delegated AoR within the Bremen ACC sector Hannover (HAN). Full responsibility is delegated to Wunstorf Radar for this airspace.

ETNW AoR.png

AoR Wunstorf

Wunstorf Radar shall inform Bremen ACC sectors HAN, FRI and EMS as well as Bückeburg Radar (ETHB APP) and Celle Radar (ETHC APP) about the opening and closing of AoR Wunstorf immediately! Additionally, Wunstorf Radar shall also inform Wunstorf TWR and Hannover TWR. 

Sub-sectors of AoR Wunstorf are activated depending on the active runways at EDDV. The virtual controller shall always select the active runways at EDDV in Euroscope to load and AoR Wunstorf correctly.

Sector Y will only be delegated from Hannover Tower to Wunstorf Radar during EDDV RWYs 27L/R and if either CTR Hannover or Wunstorf airport are IMC (Status "West to APP", see ETNW Tower SOP)During VMC, sector Y will be delegated to Wunstorf TWR. 

If Bückeburg Radar (ETHB APP) is offline, Wunstorf Radar will take over full responsibility for AoR Bückeburg and top-down responsibilities at ETHB. Therefore, Wunstorf Radar shall consult the SOP of Bückeburg before connecting to the Vatsim network.

Procedures

Arriving Traffic

Departing Traffic

IFR traffic departing from RWY 08 will not enter AoR Wunstorf. This traffic shall be transferred from Wunstorf Tower to EDWW sector Hannover directly. Local IFR traffic shall be coordinated between Wunstorf Radar and Bremen Radar individually. 

Approach Types

Wunstorf is equipped with the following approach types:

Runways ILS Z (CAT I) LOC RNP TACAN PAR SRA
08
26
02


20


The standard intercept altitude for all runways is 2000 ft respecting the MVA and neighbouring sectors. 

Low visibility approaches are not available at ETNW. 

Since Wunstorf Precision is currently not implemented on VATSIM, PAR approaches can only be conducted if traffic levels permit - if necessary, Wunstorf Radar can coordinate with civilian ATC to keep other inbound traffic outside of the airspace while a PAR approach is taking place; whether this is possible, however, depends on the current workload of civilian ATC.


Revision #9
Created 27 October 2024 16:44:02 by 1395737
Updated 16 November 2024 16:00:39 by 1395737