Skip to main content

EDDW Ground

Area of Responsibility

Bremen Ground controls the ground movement of aircraft north of the line shown below. Tower can delegate TWY F to GND control.


eddw.png

Parking and Pushback

Stands: GRP assigns parking positions.
Stands marked with A (12A, 18A) are reserved for Heavy aircraft and will block neighboring stands (12/13, 18/19) when used. 
Stands 12-19 are used with the aircraft facing southeast.

Pushbacks: Pushbacks are required for aircraft on stands 01-11. Aircraft on stands 12-19 may also taxi out, provided that they meet the restrictions for the taxiway they're taxiing onto.

De-Icing: De-icing is provided directly at the parking position.  

Taxiways

Standard routings: 

Taxiway Hotel should be avoided, as the crew of Christoph 55 might need to cross this taxiway to get to their helicopter. The main  taxiway Charlie is preferred. The pavement is not build for large aircrafts. Small aircraft of the Lufthansa Flight School/Club may use this taxiway to reach their hangar.

When runway 27 is active, for noise protection reasons, propeller aircraft and aircraft with turbine propeller engines over 2000 kg MTOW are assigned the runway junction Echo for take-off. For aircraft with an MTOW of up to 2000kg (General Aviation), the Delta runway junction should be used. 

If runway 09 is active, runway intersection Alpha and Charlie can be used, depending on where the aircraft is in the general aviation area and what the general IFR situation is.

Departures via runway 23 get a taxi via Delta and hold short of runway 27/09  and are handed over to the tower there.

Arriving traffic: [27 vacate and taxi via A, hold short N]

Helipad: [only used by CHX - other traffic via runway?]


Taxiway Restrictions

Taxiway Restriction
Delta
Maximum wingspan 36m
Echo
Maximum wingspan 36m
Golf Wingspan < 52m
Hotel Maximum wingspan 24m 
Kilo Maximum wingspan 24m
Lima Maxiumum wingspan 31m
November Wingspan < 52m
Romeo
Maximum wingspan 24m
Sierra Wingspan < 36m

Low Visibility Operations (LVO)

Cat II/III holding points shall be used and are marked as red lines in the ground layout.