ATIS Codes

Default ATISmaker URL

http://uniatis.net/atis.php?metar=$metar($atisairport)&arr=$arrrwy($atisairport)&dep=$deprwy($atisairport)&apptype=ILS&info=$atiscode

General ATIS Codes

Add the following code at the end of the ATISmakerURL to include the ATIS broadcast message. For all airports except Frankfurt the departure frequency has to be included in the ATIS!

CODE	Broadcast
&depfreq=123.123	ATTENTION! DEPARTURE FREQUENCY FOR ALL DEPARTING AIRCRAFT IS 123.123
&lvp	LOW VISIBILITY PROCEDURES IN OPERATION CAT II AND III AVAILABLE
&gto (do not use together with &lvp; at EDDF: only use with DEP-ATIS)	LOW VISIBILITY PROCEDURES IN OPERATION CAT III AND GUIDED TAKE-OFF AVAILABLE FOR RUNWAY %deprwy%

EDDF ATIS Codes

Manual Codes

CODE	Broadcast
&atistype=dep	sets the desired ATIS as departure ATIS (mandatory!)
&atistype=arr	sets the desired ATIS as arrival ATIS (mandatory!)
&ilsz	replaces ILS Y with ILS Z
&indep	EXPECT INDEPENDENT PARALLEL ILS [...]
&alternate	EXPECT ILS [...]
&rnpy	EXPECT RNP Y APCH RWY [...]
&tailwind18	TAILWIND COMPONENT RWY 18 MORE THAN 10 KT PILOTS UNABLE TO ACCEPT SHALL ADVISE ATC UPON START-UP REQUEST
&night	supresses 18 not available message
&tailwind18	TAILWIND COMPONENT RUNWAY 18 MORE THAN 10 KNOTS PILOTS UNABLE TO ACCEPT SHALL ADVISE ATC UPON START-UP REQUEST
&southonly	ALL DEPARTING ACFT VIA MARUN, OBOKA AND TOBAK EXPECT SID WITH DESIGNATOR MIKE OR WHISKEY
&birds	CAUTION FLOCK OF BIRDS IN VICINITY OF THE AERODROME
&windshearall	WINDSHEAR ALL RUNWAYS
&windshear18	WINDSHEAR RUNWAY 18
&windshear07	WINDSHEAR RUNWAY 07L 07C AND 07R
&windshear25	WINDSHEAR RUNWAY 25L 25C AND 25R

Automatic Setup

Remark	Broadcast
standard expected approach message, when 2 runways are selected	EXPECT DEPENDENT PARALLEL ILS Y APCH RWY [...] OR ILS APCH RWY [...]
active when RWY 18 selected as departure runway and 07R as arrival	ACFT DEPARTING RWY 18 EXPECT POSSIBLE DEPARTURE FROM INTERSECTION MIKE, TORA {3454} METERS, IF UNABLE ADVISE TWR ON INITIAL CONTACT
active when RWY 25L selected as arrival runway and no lvp in progress	DO NOT MISTAKE TWY MIKE FOR RWY 25C WHEN PERFORMING VISUAL APCH
active when rwy 18 is not selected as departure rwy	RWY 18 NOT IN USE DUE TO TAILWIND
always shown, except when RNP Y active	EXPECT RADAR VECTORING, GLS APCH ON REQUEST

EDSB ATIS Codes

Automatic Setup

Remark	Broadcast
standard message	ADDITIONAL INFORMATION! CAUTION! CAT I HOLDING POINT ALPHA AND ECHO ARE LOCATED ON TAXIWAY GOLF SHORT BEHIND CAT II/III HOLDING POINT

EDFM ATIS Codes

Manual Setup

Remark	Broadcast
&circling09 (select 09 as departure runway and 27 as arrival runway)	adds CIRCLING 09 to expected approach message