Departure

All sectors for Berlin Departure are dependent on the runway configuration at Berlin-Brandenburg Airport (BER/EDDB).

If there's only one Departure station online, the other Departure sector will also be covered
A second Departure controller should only connect with approval from the controller already being only. The same applies to position bookings.
Berlin Departure shall cross-couple both frequencies at any time.
All handoffs to APP/DEP shall be performed to the "correct" (/cross-coupled) sector frequency.

Procedures 07-Ops

Departure Routes


SIDs 07L	SIDs 07R

Departing traffic from different departure runways is independent as long as both aircraft are on a published procedure (vectored departures are not published procedures!)
It is Tower's responsibility to assure enough separation between Q and Z / B and K SIDs.

Special Procedures

Hoffmann-Kurve
Due to noise abatement procedures aircraft following a Q-SID out of runway 07R will perform the famous "Hoffmann-Kurve". Aircraft operators are required to fly an early right turn to the south after passing 600ft. Berlin Tower will transfer those aircraft as soon as they are established on the crosswind leg.

Berühmte Berliner Hoffmann-Kurve

Departing traffic following the LOGDO 1Q or SUKIP 1Q will have an initial climb of FL080. Special climb gradients are required in order to stay clear of arriving traffic.

DBAS4 Airspace
During 07-Ops Departure South will have a special delegated airspace inside the sector of Berlin Arrival South. This will ensure that departing traffic stays clear of any airspace of Berlin Arrival. This delegated airspace is known as the "DBAS4 Window".

Sector DBAS 4

ED-R 146
Aircraft flying on the SUKIP 1K or LOGDO 1K are excluded from the flight restriction of ED-R 146. Departing traffic with an RFL below FL105 has to be transferred to Berlin Arrival North (DBAN).

Kreuzende Directs
Pay special attention to departing aircraft flying through the DBAS 4 Window (see above). It has to be assured that departing traffic will not leave this window below FL105 when getting a direct routing, in order to keep departing traffic clear of arriving traffic.

Potential Conflict Departures - Arrivals

Procedures 25-Ops

Abflugrouten


SIDs 25L	SIDs 25R

Departing traffic from different departure runways is independent as long as both aircraft are on a published procedure (vectored departures are not published procedures!)

Special Procedures

Parallel Departures to the West
During 25-Ops you will often face SUKIP and LOGDO departures flying parallel. It might be necessary to let the aircraft cross before performing the handover to the next station. It is helpful to do the crossing at low altitudes (earliest above 5000ft). Pay special attention to vertical separation.

Direct DB433
Usually, arriving traffic via OGBER will get a direct instruction to DB433. This crosses the airspace of DBDN and therefore needs a general or individual release for Berlin Departure. This normally doesn't cause any major conflicts because traffic will cross DBDN's airspace only at a tiny bit, in the vicinity of ED-R 146.

Handoffs from Departure to Center

Traffic on the same or crossing departure routes needs to have at least a minimum separation of 5 NM before handoff to Center. It might be necessary to give level-offs to aircraft to ensure separation during crossings.

(Potential) Conflicts shall not be transferred to Center at any time!

Use the LoA for details on level agreements: https://knowledgebase.vatsim-germany.org/books/bremen-fir-edww/page/bremen-acc-internal

After coordination with Sector BOR, departures via SUKIP M748 SOGMA might be transferred to Sector MAR (climbing FL200).

Tactical Directs

Tactical Direct	Special Conditions	From Sector	To Sector
HLZ	Only during 25-Ops	DBDN	BOR
BUREL	Only during 07-Ops
POVEL	-
PODER	Only with Destination EDDK and RFL above FL245
DENOL	Only with Destination EDDL/EDLV and RFL above FL245
MAG	-	DBDS
ODLUN	-
MAXAN	-
ARSAP	-		FLG

Departure-Split

During a Departure-Split, both sectors are not allowed to give instructions to aircraft to cross the other's sector. Coordination is always necessary!

Check the LoA for handoff level between DBDN and DBDS: https://knowledgebase.vatsim-germany.org/books/bremen-fir-edww/page/bremen-acc-internal

Noise Abatement

Due to Noise Abatement Procedures, it is only possible to turn aircraft off the published procedure when above a certain altitude.

Jets: 5000ft
Props: 3000ft

Strausberg/Schönhagen

Strausberg (EDAY)

ATC Service by Departure North (DBDN)

Departures

Only during 07-Ops
IFR Clearance when Strausberg Information is offline
No ATC Service provided on the ground
Initial climb instructions need to be coordinated with Berlin Arrival

Arrivals

Only during 07-Ops
Supervision of traffic on the published procedure only
Clearance for the RNP approach will already be done by Berlin Arrival
No ATC Service provided on the ground (incl. landing clearance)

Schönhagen (EDAZ)

ATC Service by Departure South (DBDS)

Departures

Only during 25-Ops
IFR Clearance when Schönhagen Information is offline
No ATC Service provided on the ground
Initial climb instructions need to be coordinated with Berlin Arrival

Arrivals

Only during 25-Ops
Supervision of traffic on the published procedure only (potential conflicts with departures)
Clearance for the RNP approach will already be done by Berlin Arrival
No ATC Service provided on the ground (incl. landing clearance)
Report aircraft being on final to Berlin Tower (because of dependencies)